Tikka T1x 15 Round 22lr AICS Stock Compatible Magazine

Standard AICS Tikka T1x rifle stock compatible 15 round magazine.

We have gotten many requests from PRS shooters for a Tikka T1x magazine that is compatible with AICS style magazine wells and it is here finally!

After going through tens of iterations we have managed to develop a magazine that is easy to load and feeds reliably no matter the circumstances.

The magazine is about the same size as a typical AICS style magazine and has a capacity of 15 rounds!

The magazine has a viewing holes on the side in five round increments so you can quickly see how many you have loaded.

The magazine has been tested and worked flawlessly so far on:

• Tikka ACE AICS
• MDT ACC Elite Chassis System

We expect that it will function with most AICS style stocks. If the magazine ends up not fitting your particular stock please contact us and tell us your stock model and which part of the magazine is incompatible and we will either modify the magazine to fit or refund your order.

Incompatible so far:

• Old pre 2021 Tikka T1x rifles that use a wire ejector
• Vision Pro Chassis

Durability

All of our magazines are 3D printed from polycarbonate (PC) which is a tough and durable engineering filament. It has a high impact resistance, very high strength and can resist temperatures in excess of 100 °C.

The magazine body has thick body and beefy feed lips. It handles being pressed against a barricade or being used as a monopod with zero issues.

We have had no durability issues in all of our testing and use of these magazines. We have cycled over a 1000 rounds through a magazine and seen no wear on the feed lips. The low friction nature and high wear resistance of PC plastic that these are made out of helps with that.

While we don’t recommend it, we have drop tested our magazines on all sorts of surfaces including concrete and haven’t had a single one break.

If all else fails all Masiinatek products come with a five year warranty for any breakages occurring from normal usage.

Maintenance (every 500 rounds or when necessary)

• Disassemble the magazine and wipe dirt off with a cloth or a paper towel.
• In our experience normal bearing grease, ie. lithium grease works best. Silicones, oils, and even some PTFE dry lubricants tend to gum up the magazine.
• Apply a light coat of grease on the front and rear surfaces of the follower.

Made in Finland.

If you’re ordering from outside the EU you may have to deal with the customs and pay VAT in your own country.